Mercury VesselView 403 - Creating Screen Captures; Source Selection Notice

Source Selection Notice
Upon completion of the setup Wizard, a Source selection notice is displayed. Selecting Start, by pressing the Enter button, will
begin the process of searching the vessel's network for identifiable sensors and senders of data transmitting devices.
65793
Data source selection in progress. The screen will display the progress from 0 to 100 percent.
65812
When selection is complete, press the Enter button to continue. The VesselView screen will return to the main data display
mode.
65813
Creating Screen Captures
VesselView allows for the creation of screen images during realtime operation.
IMPORTANT: Always use caution when diverting your attention away from the water in front of you. Be certain that there are no
obstructions or other boats in your path.
Section 2 - Initial Screens and Setup Wizard
Page 20 90-8M0124182 eng DECEMBER 2017