Import Configuration
The setup wizard will begin by asking the operator if there is a configuration file that has been saved to the local storage in the
unit, or loaded on the USB storage device inserted into the back of the unit. This can be helpful and save setup time if the
settings and preferences to be used for this vessel are identical to a vessel which has already been used to create a
configuration file. If there is no file to import, press the Down arrow button to continue with the wizard. If there is a configuration
to import, use the file browser menu option to locate the configuration file. Refer to Section 3 ‑ File Browser.
Engine Setup
In the engine setup section of the setup wizard, the operator can select the engine model, the number of engines on the vessel,
and the number of engines, up to two, which will be displayed on a particular VesselView.
NOTE: VesselView 403 will only display data for two engines. Vessels with three or more engines will require additional
VesselView 403 units.
Press the Enter button to bring up the selection of engines. Use the arrow buttons to navigate up and down the list. Press the
Enter button when the correct engine is highlighted.
Engine selection
Section 2 - Initial Screens and Setup Wizard
90-8M0124182 eng DECEMBER 2017 Page 9
To Next Page
Loading...
Need help?
General
