92
Enter Setup
Metapace S-2 Hardware Manual
Entering preset PIN code…
1. Read the “Use preset PIN” label to enable authentication with a preset PIN.
2. Read one of the labels to specify the PIN code, in decimal or hexadecimal.
By default, the PIN code is set to “0000”. Maximum 16 characters are allowed.
3. Read the “Decimal Value” label on page 195 or the “Hexadecimal Value” label on page 196 for
the desired digits or character string.
Read the “Clear PIN Code” label first if you need to re-input the PIN code.
4. Read the “Validate” label to complete this setting.
Enter PIN Code
in Hexadecimal …
Enter PIN Code
To Next Page
Loading...
