Metapace S-2 - Test Mode; Laser Mode; Auto off Mode

34
Enter Setup
Metapace S-2 Hardware Manual
1.6.2 TEST MODE
The scanner is always scanning.
 Capable of decoding the same barcode repeatedly without removing it, for testing
purpose.
1.6.3 LASER MODE
The scanner will start scanning once the trigger is hold down.
 The scanning won't stop until (1) a barcode is decoded, (2) the pre-set timeout
expires, or (3) you release the trigger.
Note: Refer to “Scanning Timeout”.
1.6.4 AUTO OFF MODE
The scanner will start scanning once the trigger is pressed.
 The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout
expires.
Note: Refer to “Scanning Timeout”.
T
est Mode
*
Laser Mode
A
uto Off Mode