Metapace S-2 - Delay between Re-Read

To Next Page

To Previous Page

Enter Setup

Metapace S-2 Hardware Manual

1.8 DELAY BETWEEN RE-READ

This is also referred to as the “Blocking Time”, which is used to prevent the scanner from

accidentally reading the same barcode twice when the scan mode is set to any of the

following –

 Continuous mode

 Auto Power Off mode

 Alternate mode

100 ms

200 ms

800 ms

* 400 ms

2 sec

3 sec

5 sec

1 sec

Other manuals for Metapace S-2