Metapace S-2 - Page 198

188
Enter Setup
Metapace S-2 Hardware Manual
Config<CR>
Purpose To configure the cradle.
Remarks A list of the current settings will be displayed. Run HyperTerminal.exe on your
computer and change the settings one by one.
DefaultSetting<CR>
Purpose To restore the default settings.
Remarks
SingleConnection<CR>
Purpose To allow only one scanner connecting to the cradle.
Remarks
MultiConnection<CR>
Purpose To allow up to seven scanners connecting to the cradle.
Remarks
UseOnePortforAll<CR>
Purpose To use one Virtual COM port for all whenever connecting the cradle to PC via USB.
This setting requires you to connect one cradle at a time, and will facilitate
configuring many cradles via the same Virtual COM port (for administrators’ or
factory use).
Remarks