2
OPERATION
2. OPERATION
Please read all instructions before operating the AQUALAB TDL to ensure the instrument
performs to its full potential. Please contact Customer Support at any time for assistance
with installation and setup.
Please observe the following considerations carefully.
• Only allow personnel qualified by METER to carry out service work on the electrical
components.
A Certificate of Calibration will be issued upon completion of the work.
• Never remove the housing of the instrument. There are no parts inside the housing that can
be serviced or replaced by the user.
WARNING: There is a risk of damaging the instrument or of causing serious injury if the live components are touched.
• Only operate this instrument with a main power voltage specified for it (100 to 240 V AC at
50–60 Hz).
• An incorrect main power voltage can damage the instrument.
• Plug the instrument into a grounded outlet or power strip.
• Only use the fuse type and rating specified for this instrument (Section3.1).
If the instrument is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
PRECAUTIONS
METER instruments are built to the highest standards, but misuse or neglect may damage
the device and possibly void the manufacturer’s warranty. Before using the AQUALAB TDL,
follow the recommended user instructions and arrange proper protections to safeguard the
instrument from damage.
2.1 INSTALLATION
Follow the steps listed in Table 1 to set up the AQUALAB TDL.
Table 1 Installation
Preparation
Select Clean, Level Location
Preserve cleanliness to prevent contamination of the sample chamber.
Maintain a level surface to reduce the chance of spilling sample material and
contaminating the sample chamber.
Select a location where the temperature remains fairly stable to avoid
temperature changes that can affect accuracy (away from air conditioner and
heater vents, open windows, etc.)
NOTE: Always ensure the sample chamber is empty prior to moving the instrument.
To Next Page
Loading...
Need help?
General
