MI 3201 TeraOhm 5 kV Plus Performing measurements
12
bottom left angle of LCD screen the plug character and the flashing battery indicator will
appear to indicate that the batteries are charging.
Note: If batteries are defective or missing, the charger will not work. In lower left corner
of LCD screen only plug character will be appeared (without battery indicator).
If the instrument is connected to the mains supply when the instrument is turned ON,
the instrument will automatically switch from the battery supply to the main supply. In
bottom left corner of LCD screen, the plug character will appear. If instrument is not in
measuring mode*, the internal charger will begin to charge the batteries. In bottom left
corner of LCD screen battery indicator will start to flash, indicating that the batteries are
charging.
Note: It is not recommended to connect or disconnect the instrument to mains supply
while the instrument is in measuring mode*.
*measuring mode: When the instrument is performing a test.
Backlight operation (battery powered instrument)
After turning the instrument ON the LCD backlight is automatically turned ON. It can be
turned OFF and ON by simply clicking the LIGHT key.
Backlight operation (mains powered instrument)
After turning the instrument ON the LCD backlight is automatically turned OFF. It can be
turned OFF and ON by simply clicking the LIGHT key.
Off function
The instrument can be switched OFF only by pressing the ON/OFF key. The auto-off
function is not available to allow long-term measurements to be performed.
4.1.1 Configuration
The configuration function enables the selection and adjustment of parameters (Table
1a.) of the measurements. In addition memorized results can be cleared in this menu.
(Fig. 5a).
In the lower section of the display the power supply status is shown.
The following procedure must be carried out when adjusting some of the configuration
parameters:
1. Use and arrows to select parameter (line) to be adjusted.
2. Use and
arrows to change the value of the selected parameter. If there are
two or more sub-parameters in one line (e.g. date and time) then use the SELECT
key to skip to the next sub-parameters and back.
To clear all memory locations:
1. Select Configuration from the main menu
1. Highlight the Memory Clear option using and arrows.
2. Press the SELECT key, (“Press MEM to confirm!” message will be displayed).
3. Press the MEM key to clear all memory locations or ESC to cancel the activity.
To Next Page
Loading...
Need help?
General
