EasyManuals Logo

METREL TeraOhm 5kV Plus User Manual

METREL TeraOhm 5kV Plus
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
MI 3201 TeraOhm 5 kV Plus Maintenance
42
7 Maintenance
7.1 Inspection
To maintain the operator’s safety and to ensure the reliability of the instrument it is
advisable to inspect the instrument on a regular basis. Check that the instrument and its
accessories are not damaged. If any defect is found please consult your service center,
distributor or manufacturer.
7.2 Inserting and charging batteries for the first time
Battery cells are stored in the bottom section of the instrument casing under the battery
cover (see Fig. 32). When inserting batteries for the first time please note the following:
Disconnect any measurement accessories or mains supply cable connected to
the instrument before opening the battery cover to avoid electric shock.
Remove the battery cover.
Insert the batteries correctly (see Fig. 32), otherwise the test instrument will
not operate!
Replace the battery cover and fixed the cover back in place.
Connect the instrument to the mains power supply for 14 hours to fully charge batteries.
(Typical charging current is 300 mA).
When you charge the batteries for the first time, it normally takes about 3 charge and
discharge cycles for the batteries to regain full capacity.
7.3 Replacing and charging batteries
The instrument is designed to be power by rechargeable battery supported by mains
supply. The LCD contains an indication of battery condition (lower left section of LCD).
When the low-battery indication appears the batteries have to be recharged, connect
the instrument to the mains power supply for 14 hours to recharge cells. The typical
charging current is 300 mA.
Note:
The operator does not need to disconnect the instrument from mains supply after the
full recharging period. The instrument can be connected permanently.
Fully charged rechargeable batteries can supply the instrument for approx. 4 hours.
(Continues testing at 5kV)
If the batteries have been stored for a long time, it normally takes about 3 charge and
discharge cycles for the batteries to regain full capacity.
Battery cells are stored in the bottom section of the instrument casing under the battery
cover (see Fig. 32). In case the batteries become defective please note the following:

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the METREL TeraOhm 5kV Plus and is the answer not in the manual?

METREL TeraOhm 5kV Plus Specifications

General IconGeneral
BrandMETREL
ModelTeraOhm 5kV Plus
CategoryTest Equipment
LanguageEnglish

Related product manuals