Metrohm 794 Basic Titrino - 2.15 Current sample data, key <SMPL DATA>

2.11. Data output
794 Basic Titrino
58
2.11 Data output
Reports for the output at the end of a determination
With <DEF>, the report sequence at the end of the
determination is defined.
The entries are specific to the method and are stored in
the method memory.
report:
Definition of report blocks to be printed automatically at
the end of the determination.
The display texts of the Titrino are shown to the left.
The values are the default values.
>report
report:
report:full;curve
Report sequence (input range depends on the mode:
DET: full, short, mplist, curve, derive, comb, scalc full,
scalc srt, param, calc, calib, ff
MET: full, short, mplist, curve, scalc full, scalc srt,
param, calc, calib, ff
SET, MEAS, CAL:
full, short, scalc full, scalc srt, param, calc, calib,
ff
TIP: full, short, scalc full, scalc srt, param, calc, ff
Select a block with <SELECT>. If you require more
than one report block, set a ";" as a delimiter between
the blocks.
Meaning of the report blocks:
full Full result report with raw results, calculations and statistics.
short Short result report with calculations and statistics.
mplist Measuring point list.
curve Titration curve (with DET and MET) or volume vs. time (with SET) or
measured value vs. time (with MEAS)
derive 1st derivative of the titration curve (with DET)
comb Combined titration curve and 1st derivative (with DET)
scalc full Full report of silo calculations.
scalc srt Short report of silo calculations.
param Parameter report.
calc Report with formulas and operands.
calib Calibration data.
ff Form feed on printer.
DEF
(
2
def
>report