3.2. Remote control commands
794 Basic Titrino
86
&Mode
Object Description Input range Reference
& Root
├ Mode Mode $G, $S, $H, $C 3.2.2.1.
: ├ .QuickMeas Rapid meas. in basic mode $G, $S 3.2.2.2.
├ .Select Mode selection DET,MET,SET,
│ MEAS,CAL,TIP 3.2.2.3.
├ .DETQuantity Measured quantity for DET pH, U, Ipol, Upol ditto
├ .METQuantity Measured quantity for MET pH, U, Ipol, Upol ditto
├ .SETQuantity Measured quantity for SET pH, U, Ipol, Upol ditto
├ .MEASQuantity Measured quantity for MEAS pH, U, Ipol, Upol, T ditto
├ .Name Name of current method read only/read+write 3.2.2.4.
├ .Parameter* Parameter of current mode, page 87ff
│
├ .Def Definitions for data output
│ ├ .Formulas Calculation formulas
│ │ ├ .1 for result 1
│ │ │ ├ .Formula Calculation formula special 3.2.2.5.
│ │ │ ├ .TextRS Text for result output up to 8 ASCII char ditto
│ │ │ ├ .Decimal Number of decimal places 0...2...5 ditto
│ │ │ ├ .Unit Unit for result output up to 6 ASCII char ditto
│ │ │ : up to 9 results
│ ├ .SiloCalc Silo calculations
│ │ ├ .Assign Assignment
│ │ │ ├ .C24 Store as variable C24 RSX,EPX,CXX 3.2.2.6.
│ │ │ ├ .C25 Store as variable C25 RSX,EPX,CXX ditto
│ │ ├ .MatchId Matching of Id's id1, id1&2, all, OFF ditto
│ ├ .ComVar Assignment of common variables
│ │ ├ .C30 for C30 RSX,EPX,CXX,MNX 3.2.2.7.
│ │ ├ up to C39
│ ├ .Report Reports at the end of determination
│ │ ├ .Assign Assignment depends on mode 3.2.2.8.
│ ├ .Mean Assignment for mean calculation
│ │ ├ .1 MN1
│ │ │ ├ .Assign Input of variable RSX, EPX, CXX 3.2.2.9.
│ │ │ up to 9
│ ├ .TempVar Assignment of temporary variables
│ │ ├ .C70 for C70 RSX,EPX,CXX 3.2.2.10.
│ │ ├ up to C79
├ .CFmla Calculation constants
│ ├ .1 Calculation constant C01
│ │ ├ .Value Input of value 0...±999 999 3.2.2.11.
│ ├ up to C19
To Next Page
Loading...
