Metrohm 892 - Replacing Fuses

3.3 Power connection
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
22
￭￭￭￭￭￭￭￭
892 Professional Rancimat
Power plug according to customer requirements (6.2122.XX0), designed
for a minimum of 10 A.
1
Plugging in the power cord
￭ Plug the power cord into the instrument's power socket.
￭ Connect the power cord to the energy supply.
NOTICE
To switch off the instrument, you must unplug the power cord
from the energy supply.
3.3.2 Replacing fuses
The fuse holder of the 892 Professional Rancimat contains two fuses:
￭ Two slow-acting 4 A fuses
WARNING
Ensure that the instrument is never put into operation with fuses of
another type, otherwise there is a risk of fire!
Proceed as follows to replace defective fuses:
1
Pulling out the power cord
￭ Pull the power cord out of the power socket of the 892 Profes-
sional Rancimat.
2
Removing the fuse holder
￭ Release the fuse holder located on the rear of the instrument
above the power socket by pressing the catch spring and pull out
the holder completely.