￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Operation
892 Professional Rancimat
￭￭￭￭￭￭￭￭
39
￭ Clean the reaction vessel covers with acetone or 2-propanol or
in the dishwasher and rinse with distilled water.
Pre-clean with dishwashing detergent in the case of severe con-
tamination.
￭ Then heat the reaction vessel covers in the drying oven for 2
hours at 80 °C.
NOTICE
Replace the reaction vessel covers if they no longer sit tightly on
the reaction vessel or the material is brittle.
3
Cleaning the tubing
￭ Clean the silicone tubing with acetone or 2-propanol or in the
dishwasher and rinse with distilled water.
Pre-clean with dishwashing detergent in the case of severe con-
tamination.
￭ Then heat the silicone tubing in the drying oven for 2 hours at
80 °C.
4.3.5 Cleaning the oil separator
Figure 17
Oil separator (6.2753.200), disassembled
1
Body
Body with the IN and OUT connectors.
2
Base
Base with O-ring (6.1454.050) used for seal-
ing the oil separator.
1
Disassembling the oil separator
￭ Remove the base.
To Next Page
Loading...
