4.3 Determinations
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
40
￭￭￭￭￭￭￭￭
892 Professional Rancimat
NOTICE
Remove the base carefully.
Do not use sharp or pointed tools.
2
Cleaning the oil separator bodies
￭ Clean the oil separator bodies with acetone or 2-propanol or in
the dishwasher and rinse with distilled water.
Pre-clean with dishwashing detergent in the case of severe con-
tamination.
￭ Then heat the oil separator bodies in the drying oven for 2
hours at 80 °C.
3
Cleaning the oil separator bases
￭ Clean the oil separator bases with 2-propanol or in the dish-
washer and rinse with distilled water.
Pre-clean with dishwashing detergent in the case of severe con-
tamination.
￭ Then heat the oil separator bases in the drying oven for 2
hours at 80 °C.
￭ Mount new O-rings where necessary.
NOTICE
Do not allow the oil separator bases to come into contact with
acetone for extended periods of time.
NOTICE
Replace the O-rings if they no longer sit tightly on the body or if
the material is brittle.
4
Assembling the oil separator
￭ Press the base onto the body by hand until it sits flush.
To Next Page
Loading...
