>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
At the end of the transfer, a normal startup sequence will occur.
4. Test to confirm the upgrade.
• Exit the DOS program and unhook the RS-232 transfer ca-
ble from the QA-1290.
• Switch the QA-1290 OFF, then turn it back ON.
Verify that the new firmware version is installed while the QA-
1290 is running its start sequence. The firmware version will be
displayed in Startup Screen Menu 3.
3-8
To Next Page
Loading...
