Page 19
2.4 Safety notes
2.4.1 General safety notes
The servo drive corresponds to IP20 degree of protection as well as pollution degree 2.
Make sure that the environment corresponds to this degree of protection and pollution
degree.
Only use replacement parts and accessories approved by the manufacturer.
The devices must be connected to the mains supply as per EN regulations, so that they
can be cut off the mains supply by means of corresponding separation devices (for
example main switch, contactor, power switch).
The servo drive may be protected using an AC/DC sensitive 300 mA fault current
protection switch, type B (RCD = Residual Current protective Device).
Gold contacts or contacts with a high contact pressure should be used to switch the
control contacts.
Preventive interference rejection measures should be taken for control panels, such as
connecting contactors and relays using RC elements or diodes.
The safety rules and regulations of the country in which the device will be operated must
be complied with.
The environment conditions defined in the product documentation must be kept. Safety-
critical applications are not allowed, unless specifically approved by the manufacturer.
For notes on installation corresponding to EMC, please refer to chapter 8.14 Notes on
safe and EMC-compliant installation (page 109). The compliance with the limits required
by national regulations is the responsibility of the manufacturer of the machine or
system.
The technical data and the connection and installation conditions for the servo drive are
to be found in this product manual and must be met.
DANGER!
The general setup and safety regulations for work on power installations (for example
DIN, VDE, EN, IEC or other national and international regulations) must be complied
with.
Non-compliance may result in death, personal injury or serious property damages.
Product Manual „Servo drives ARS 2100 SE“ Version 5.0
To Next Page
Loading...
Need help?
General
