EasyManua.ls Logo

Mhouse WT1S - Indicator Light FL100; Photocells PH100

Mhouse WT1S
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Indicator light FL100
• Product type: flashing indicator light for automations of automatic gates and doors. The device incorporates a radio antenna for reception of the
transmitter signal
• Adopted technology: indicator light with 12V 21W lamp controlled by the control units for MHOUSE automations
• Lamp: 12V, 21W, with fitting BA15 (vehicle type lamp)
• Power supply: the device can only be connected to the terminals “FLASH” and “AERIAL” of the MHOUSE automation control units
• Ambient operating temperature: -20 ÷ 50°C
• Use in particularly acid, saline or potentially explosive atmospheres: no
• Assembly: su un piano orizzontale oppure su una parete verticale
• Protection rating: IP 44
• Dimensions/weight: 120 x 60, h 170mm / 285g
Photocells PH100
• Product type: Presence detector for automations of automatic gates and doors (type D according to standard EN 12453) comprising a transmit-
ter “TX” and receiver “RX”
• Adopted technology: Optical, by direct interpolation of TX-RX with modulated infra-red rays
• Detection capacity: Opaque objects located on the optical axis between TX and RX, larger than 50 mm and moving slower than 1.6 m/s
• TX transmission angle: 20° approx.
• RX reception angle: 20° approx.
• Usefule range: 10 m for maximum TX-RX misalignment ±5° (the device can signal an obstacle even in the event of particularly adverse weather
conditions)
• Power supply/output: The device can only be connected to the “ECSBus” networks from which it receives mains power, and sends the output
signals
• Absorbed power: 1 ECSBus unit
• Max. cable length: Up to 20 m (observe warnings regarding the minimum section and type of cables)
• Possibility of address assignment: Up to 6 detectors with protection function. Automatic synchronisation prevents interference between the
various detectors
• Ambient operating temperature: -20 ÷ 50°C
• Use in particularly acid, saline or potentially explosive atmospheres: No
• Assembly: Vertical, wall-mounted
• Protection rating: IP 44
• Dimensions/weight (TX and RX): 95 x 65 h 25mm / 65g
GTX4 Transmitters
• Product type: Radio transmitters for remote control of automations for automatic gates and doors
• Adopted technology: Encoded AM OOK radio modulation
• Frequency: 433.92 Mhz
• Encoding: 64 Bit rolling code (18 billion billion combinations)
•Keys: 4, each key can be used for different commands of the same control unit or to control different control units
• Radiated power: 0.0001W approx.
• Power supply: 6V +20% -40% with 1 lithium battery type CR2016
• Battery life: 3 years, estimated on the basis of 10 commands/day lasting 1s at 20°C (battery efficiency is reduced at low temperatures)
• Ambient operating temperature: -20°C ÷ 50°C
• Use in particularly acid, saline or potentially explosive atmospheres: No
• Protection rating: IP40 (use in the home or protected environments)
• Dimensions/weight: 72 x 31 h 11mm / 18g
––––––––––––
NOTES: • The kit WT1s and WT2s is produced by Nice S.p.a. (TV) I, MHOUSE is a commercial trademark owned by the group Nice S.p.a. • In order
to improve its products, NICE S.p.a. reserves the right to modify the technical characteristics at any time without prior notice. In any case, the manu-
facturer guarantees their functionality and fitness for the intended purposes. • All technical specifications refer to a temperature of 20°C.
English
34 – English

Table of Contents