Why does my Mhouse SL1 Gate Opener start then immediately reverse?
If the Mhouse Gate Opener starts but immediately reverses, it might be due to the selected force being too low to move the gate. First, check for any obstacles obstructing the gate's movement. If there are no obstructions, increase the force as described on page 21.
What to do if Mhouse SL1 doesn't start and the flashing light flashes a few times?
If the Mhouse Gate Opener manoeuvre doesn't start and the flashing light flashes a few times, ensure the STOP input is active, indicated by the "STOP" LED [C] being on. If the LED isn't on, inspect the devices connected to the STOP input. Also, the photocell test performed at the start of each manoeuvre needs to be successful; inspect the photocells, referring to Table 11 on page 27.
What to do if my Mhouse SL1 manoeuvre doesn't start and the flashing light is off?
If the Mhouse Gate Opener manoeuvre doesn't start and the flashing light is off, make sure that the command is actually received. If the command reaches the OPEN input, the corresponding "OPEN" LED [D] must light up; if you are using the radio transmitter, the "ECSBus" LED must make two long flashes.
How to troubleshoot Mhouse SL1 when the manoeuvre doesn't start and the "ECSBbus" LED [B] doesn't flash?
If the Mhouse Gate Opener manoeuvre does not start and the "ECSBbus" LED [B] does not flash, ensure that the power cord is properly plugged into the mains outlet. Also, check the fuses [E] or [F] to see if they are blown. If necessary, identify the reason for the failure and then replace the fuses with others having the same current rating and characteristics.
What to do if the Mhouse SL1 Gate Opener works but the flashing light doesn't?
If the Mhouse Gate Opener manoeuvre is carried out but the flashing light does not work, make sure that there is voltage on the flashing light's FLASH terminal during the manoeuvre (being intermittent, the voltage value is not important: approximately 10-30Vac); if there is voltage, the problem is due to the lamp; in this case replace the lamp with one having the same characteristics.
How to fix Mhouse SL1 Gate Opener when the radio transmitter doesn't emit a signal?
If the Mhouse Gate Opener radio transmitter does not emit any signal (the LED [A] does not light up), check to see if the batteries are exhausted, if necessary replace them (page 36)
Details the SL1K electromechanical gearmotor, its features, and installation.
Lists checks for gate suitability and site conditions before installation.
Outlines preparation for wiring and connecting the SL1 to mains power.
Step-by-step guide for mounting the gearmotor on gates without a rack.
Step-by-step guide for mounting the gearmotor on gates with a rack.
Detailed steps for connecting various devices to the SL1K control unit.
Final validation and handover procedures for the automation system.
Table of common symptoms, probable causes, and solutions for system errors.
General| Brand | Mhouse |
|---|---|
| Model | SL1 |
| Category | Gate Opener |
| Language | English |
To Next Page
