Mhouse SL1 - Release Keys; PH1 Photocells; KS1 Key-Operated Selector Switch; FL1 Flashing Light with Incorporated Aerial

6 Instructions SL1
2.3.3 PH1 photocells
The pair of PH1 wall-mounted photocells, once they are connected to
the control unit, enable the detection of obstacles found on the optical
axis between the transmitter (TX) and the receiver (RX).
2.3.4 KS1 Key-Operated Selector Switch
The KS1 key-operated two-position selector switch enables gate
control without using the radio transmitter. It is equipped with internal
light for locating in the dark.
There are two commands, which depend on the direction of rotation of
the key: "OPEN" and "STOP"; then the key, which is spring loaded,
returns to the centre position.
Figure 6
2.3.5 FL1 flashing light with incorporated aerial
The flashing light is controlled by the control unit and signals danger
when the gate is moving. Inside the flashing light there is also the aerial
for the radio receiver.
Figure 7
2.3.6 TX4 Radio Transmitters
The radio transmitters are used for the remote control of the gate
opening and closing manoeuvres. They feature four buttons that can all
be used for the 4 types of command to a single automation unit, or to
control up to 4 different automation units.
The transmission of the command is confirmed by the LED [A]; an eyelet
[B] allows them to be hung on a keyring.
Figure 8
B
A
Figure 5
The three keys enable the gearmotor to be released in the event of a
power failure.
2.3.2 Release keys
Figure 4
Table 3: List of small parts for PH1 Q.ty
HI LO 4X9.5 screw 4 pcs.
3.5X25 self-tapping screw 4 pcs.
s 5 c nylon screw anchor 4 pcs.
Table 4: List of small parts for KS1 Q.ty
HI LO 4X9.5 screw 4 pcs.
3.5X25 self-tapping screw 4 pcs.
s 5 c nylon screw anchor 4 pcs.
Table 5: List of small parts for FL1 Q.ty
4.2X32 self-tapping screw 4 pcs.
s 6 c nylon screw anchor 4 pcs.