MICOM-3F/3T/3R HF-SSB Owner’s Guide
92
• MNT
MultiNet: enable/disable the scanning of multiple ALE nets. When enabled, this
feature lets the radio communicate with stations in nets other than the currently
selected net.
• MxCH
Maximum Scan Channels: when MultiNet is enabled, the time needed for scanning
all the nets may be rather long. This parameter is used to adapt the duration of the
calling signal to the number of scanned net, to ensure that communications are not
disrupted. You can select between automatic selection, or select a value in the
range of 0 to 59 seconds.
• ANY
AnyCall: enable/disable the sending AnyCalls.
• WILD
Wildcard: enable/disable the sending wildcard calls.
• AMD
Automatic Message Display: enable/disable the sending AMD messages.
• ILNK
Inlink: enable/disable the inlink facility, which enables notifying other call
participants when each participant disconnects from the link. All participants must
be programmed to use the same selection (either YES or NO).
Do not enable the inlink function when communicating with a radio that does not
support the full ALE capabilities in accordance with MIL-STD-188-141B.
• BDLK
Bidirectional link: enable/disable automatically setting up a link on the best channel
after a bidirectional handshake with an individual station.
The ALE options have the following factory-default values:
• PTT Timeout
No timeout
• Alert
Yes
• External Alarm
Yes
• Auto Address
No
• Quick Call
Yes
• Minimum LQA score
0
• Accept Link Timeout
Yes
• MNT
Yes
• MxCH
Auto
• ANY
Yes
• WILD
Yes
• AMD
Yes
• ILNK
No
• BDLK
No
When configuring ALE options, you do not need to define all parameters – change only those for
which the factory-default values are not suitable.
To Next Page
Loading...
