Micom 3T - To Return a Call to a Station Registered in the Stack; To Remove an Address from the Stack

MICOM-3F/3T/3R HF-SSB Owner’s Guide
52
➤ To return a call to a station registered in the stack:
1. Press STAK (F3).
2. Use the UP/DOWN keys to scroll to the required call.
3. Press CALL (F1).
4. Press PAGE (F2) if you want to attach a message when you reply to the call.
5. Press CHAN (F3) if you want the call to be initiated on a specific channel in the currently
used net.
Note
The CHAN (F3) key is displayed only if the radio is in the ALE mode.
6. Press SEND (F1) or ENTER to initiate the call.
Note
After initiating a call to a station, its page in the stack is automatically deleted,
together with all other calls from the same address.
➤ To remove an address from the stack:
The radio automatically removes an address from the stack in the following cases:
• When the operator calls a station registered in the caller stack, all stack calls containing
that address are erased from the stack, regardless of whether the call was returned from
within the stack or during an individual call.
• The stack can contain up to ten addresses. When the stack is full and a new address
comes in, the new address replaces the oldest address in the stack.
In addition, you can manually remove an address from the stack as follows:
1. Press STAK (F3).
2. Use the UP/DOWN keys to scroll to the required call.
3. Press ERAS (F2).
4. Press YES (F1) to confirm or, NO (F2) to cancel the deletion.