Using Automatic Link Establishment (ALE)
65
Transmitting Net Calls
Before starting, select the net you want to use as explained on page 53. However, when MultiNet is
enabled, you will be prompted for a net number as soon as you start a call.
Notes
• You can program nets using the front panel, the MRC, or the RSS.
• The radio must be programmed as a MASTER radio in the net (an ALE
Programming option) in order to be able to transmit net calls.
➤ To transmit a net call:
1. Press CALL (F1).
The radio displays the last called address.
If you see the net you want, skip directly to Step 5 below,
otherwise continue as explained below.
MICOM-3
SEND
PAGE
CHAN
CALL
1001
I
2. Select the NET option as explained on page 61.
MICOM-3
SEND
PAGE
CHAN
CALL
NET 1
3. Press PAGE (F2) if you want to attach a message to the call.
4. Press CHAN (F3) if you want to initiate the call on a specific
channel.
5. Press SEND (F1) or ENTER to initiate the call.
The radio now starts the link set up process. During this
process, you will see TO alternating with the number of the
channel on which the set up request is being sent.
Note
While the radio is initializing the link, you can press
STOP (F1) or ESC to abort the entire process.
When a net call is transmitted, each member in the net
responds to the call and the initiator of the call receives an
indication of the response on the display.
MICOM-3
LINK
1111
6. After links have been established, you can start talking.
7. To end the call, press ESC.
MICOM-3
END CALLING
To Next Page
Loading...
