Micom 3T - To Send a Message During a Call (Link State)

MICOM-3F/3T/3R HF-SSB Owner’s Guide
60
➤ To send a message during a call (link state):
1. Press PAGE (F2).
Note
If this function key is not displayed, you cannot send a
message in the present mode.
MICOM-3
PAGE
MON
LINK
1009
I
2. Select or edit the desired message as explained on page 58.
3. Press SEND (F1) or ENTER to send the message.
MICOM-3
SEND
EDIT
CHAN
<->
AMD11
11 AMD MESS
4. The radio now starts the link set up process for this message
(this process is similar to the process used to set up the link for
this call). During this process, you will see TO alternating with
the number of the channel being used.
Notes
• While the radio is initializing the link, you can
press STOP (F1) or ESC to abort the entire
process.
• If the link needed to send the message to the
selected station cannot be set up, you will see
for a few seconds a flashing NO LINK message.
MICOM-3
STOP
TO
1234
MICOM-3
STOP
CH 2
1234