Micom 3T - Using the New Station Address Filter; To Edit the Received Addresses and Add Addresses to the ALE Directory

MICOM-3F/3T/3R HF-SSB Owner’s Guide
94
Using the New Station Address Filter
To help you add new station addresses to the ALE directory of your radio set in a controlled manner,
MICOM-2 has a special ALE address filter. To enable this filter, enable the Auto Address function on
the
PROG>ALE>OPT>AADR
menu (this function can also be enabled by means of the RSS).
When enabled, the address filter compares the source address of each call received by your radio set
with the addresses stored in the ALE directory. When the first new unlisted address is found, it is
stored in a special memory stack, and you are notified that at least one unlisted address has been
detected by adding the option RCV (F2) under
PROG>ALE
, after the
NET
option. When you want
to check the addresses stored in the stack, you select RCV (F2) and then decide whether to erase an
address or add it to the ALE directory of your radio set.
Up to 20 new addresses can be stored in this stack, which is organized as a FIFO stack: this means
that when a new address, different from all the previously detected addresses, is received while 20
addresses are already stored, it will replace the oldest address.
The information on the received addresses is automatically erased when the radio is turned off; only
addresses added to the directory remain in the directory.
➤ To edit the received addresses and add addresses to the ALE directory:
1. Press MENU (F1) and select ALE (F2)
2. When addresses are stored in the new received addresses
stack, you will see the RCV (F2) option. Press RCV (F2) to
display the RCV screen.
MICOM-3
ADD
ERAS
SAVE
RCV
5061
3. You will see RCV screen. The screen displays the last detected
unlisted address. Use the UP/DOWN arrows to display the
desired address (the display is cyclical).
MICOM-3
NET
RCV
DIR
AMD
ALE
PROGRAMMING
I
4. When the desired address is displayed, press the key corresponding to the action to be
performed:
• To delete the address from the stack, press ERAS (F2).
• To add the address to the directory, press ADD (F1). The address is removed from
the stack.
5. To confirm, press SAVE (F4).
6. Repeat the actions until all the desired addresses are processed. When done, press ESC to
end.
If the stack is now empty, the RCV (F2) option is no longer displayed on the ALE menu.