Micom 3T - Programming Channels; To Enter the Channel Programming Mode

MICOM-3F/3T/3R HF-SSB Owner’s Guide
82
Programming Channels
➤ To enter the Channel Programming mode:
1. Enter the Radio Programming menu (page 79).
MICOM-3
RADIO
PROGRAMMING
CHAN
PRMT
OPTS
2. Press CHAN (F1).
MICOM-3
GET
STOR
ERAS
PWR
CHAN
PARAMETERS
USB
I
The CHAN menu provides the following options (see also Figure 6):
• GET
GET retrieves a channel already programmed in MICOM-3. Retrieving a channel
retrieves all the parameters defined for that channel. You can store these
parameters as a new channel using the STOR function, and then edit the
parameters as required.
• STOR
Store the current set of parameters in a selected channel.
Note
GET and STOR are used to copy the channel parameters from one channel to
another.
• ERAS
ERAS is used to delete (erase) a channel. Actually, this action only replaces the
user-modified parameters of the channel with the factory-default parameters, but
marks the channel as not programmed.
• PWR
Select the channel transmit power level. Four transmit power levels can be
selected:
• LOW – 25 W nominal
• MED – 62.5 W nominal
• HIGH – 100 W nominal
• MAX – 125 W nominal.
• FREQ
Select the channel frequency. MICOM-3 offers four frequency options:
• SMPX (Simplex Frequency): the same frequency is used for both transmission
and reception.
• DPLX (Duplex Frequency): transmits on one frequency and receives on a
different frequency.
• RXO (Receiving Only Frequency): defines a frequency for reception only.
Transmission on that frequency is disabled.
• TXO (Transmitting Only Frequency): defines a frequency for transmission
only. You cannot receive on that frequency.