Micom 3T - To Store a Frequency in a Channel; Storing Frequencies

Basic Operating Instructions
29
MODE (MORE, F2) – selects the operation mode (SSB, AME or
PLT).
MICOM-3
FREQ
MODE SSB
USB
SSB
AME
PLT
SQ
AGC (MORE, F3) – controls the automatic gain control
(fast/slow/off).
MICOM-3
FREQ
AGC FAST
USB
PWR
MODE
AGC
BW
I
SQ
BW (MORE, F4) – selects the filter bandwidth.
MICOM-3
FREQ
BW 2.7
USB
2.1
2.7
3.0
3.3
I
SQ
RCLV (MORE, MORE, F1) – displays the receive level when F1 is pressed.
STOR (MORE, MORE, F2) – stores the frequency parameters in the selected channel.
<-- (MORE, MORE, F3) and --> (MORE, MORE, F4) – move the cursor backwards and
forwards. When these function keys are used in conjunction with the UP/DOWN scroll keys,
the frequency scrolls according to the location of the cursor, enabling you to change the
frequency with greater ease.
Storing Frequencies
You can store specific frequencies and frequency parameters in channels which you have
programmed (see Programming Channels on page 82).
➤ To store a frequency in a channel:
1. If you are not in the Frequency mode, press MENU to display
the Menu screen.
MICOM-3
CHAN
FREQ
ALE
BIT
MENU
I
2. Press FREQ (F2).
The last used frequency blinks, and the frequency type is displayed in the top line.
3. If you wish to use the displayed frequency and frequency type, press ENTER. If the
frequency type is DPLX, press ENTER twice to accept both transmission and reception
frequencies.
or
Change the frequency type and the frequency as required (see To change the current
frequency/frequencies on page 23).
4. If necessary, select the other parameters, using the MORE key and pressing the required
function keys (see To select frequency mode options on page 27).
5. Press MORE twice, and then press STOR (F2).