Micom 3T - Page 42

MICOM-3F/3T/3R HF-SSB Owner’s Guide
24
The current frequency type is displayed in the top line,
followed by the frequencies in use.
MICOM-3
SMPX
DPLX
RXO
TXO
DPLX
F
14,000.00
USB
SQ
2. If necessary, change the frequency type by pressing the relevant function key:
SMPX (F1), DPLX (F2), RXO (F3) or TXO (F4).
Note
Different frequency types may have default frequency settings, which will appear
automatically when that frequency type is selected.
3. If you are using the SMPX, RXO or TXO frequency type, and you wish to use the
displayed frequency, press ENTER.
or
Enter a new frequency.
There are two ways to change the frequency.
Method A:
• Press LEFT/RIGHT to move the cursor to the digit in the frequency value that you
want to change. The blinking digit indicates the cursor location.
• Press UP/DOWN to scroll to the value of your choice.
Method B:
Type the frequency on the keypad.
The frequency digits blink, indicating that the selection has
not yet been confirmed.
When the desired frequency is displayed, press ENTER to
confirm your choice.
MICOM-3
BACK
CLR
SMPX
F
12,345.67
USB
SQ
4. If you are using the DPLX frequency type, the frequency
displayed first is the Rx frequency. If you want to use the
displayed frequency, press ENTER.
MICOM-3
SMPX
DPLX
RXO
TXO
DPLX
R
15,000.00
USB
SQ
or
Enter a new frequency.
The frequency digits blink, indicating that the selection has
not yet been confirmed.
When the desired frequency is displayed, press ENTER to
confirm your choice.
MICOM-3
BACK
CLR
DPLX
R
23,456.00
USB
SQ
After confirming the Rx frequency, the Tx frequency blinks in the display.