MICOM-3F/3T/3R HF-SSB Owner’s Guide
70
• To send a double-selective AnyCall, enter two
characters.
MICOM-3
?
<--
CLR
ALL
ENDING:59
7. Confirm your selection by pressing ENTER (see below examples for the 3 types of
addresses).
MICOM-3
SEND
PAGE
CHAN
SEL
CALL
ANY
@@
?
MICOM-3
SEND
PAGE
CHAN
SEL
CALL
ANY
@@
2
MICOM-3
SEND
PAGE
CHAN
SEL
CALL
ANY
@
59
8. Press PAGE (F2) if you want to attach a message to the call.
9. Press CHAN (F3) if you want to initiate the call on a specific channel.
10. Press SEND (F1) or ENTER to initiate the call.
The radio now starts the AnyCall process. During this process, you will see TO alternating
with the number of the channel on which the request is being sent.
Note
You can press STOP (F1) or ESC to abort the entire process.
When an AnyCall is transmitted, the initiator of the call
receives an indication of each station answering the call (its
address flashes in the display, until replaced by the next
answering station).
MICOM-3
LINK
1111
11. After a programmed interval (or after 16 stations answer,
whichever comes first), the link is established. Now you can
start talking.
MICOM-3
PAGE
MON
LINK
ANY
I
12. To end the call, press ESC.
MICOM-3
END CALLING
To Next Page
Loading...
