8.13 Back-check Position (70%-98%)
• This setting is to adjust the door Back-check position of the Opening cycle.
• Use the "UP" and "DOWN" buttons to set the starting point for the Back-check position.
• Activate the door. During the Opening cycle, check the position where the Back-check begins and the door
starts to slow down.
• Check this setting is correctly adjusted.
• In windy conditions, set to 70%.
8.14 Push & Go (Yes/No)
• This setting is to Enable or Disable the Push & Go feature, also known as Manual Activation, when the door is
Manually pushed or pulled open by hand.
• Caution: Do not activate this feature without training and specifically requested by the end user.
• Use the "UP" and "DOWN" buttons to Disable or Enable this feature.
8.15 Push & Go Active Time (01-30 seconds)
• This setting is to adjust the duration of the door Open cycle in seconds from when the door is Manually pushed
Open to when the Push & Go feature is enabled.
• Use the "UP" and "DOWN" buttons to select the desired Opening time.
8.16 Power Close (Yes/No)
• WARNING: You should always install a Presence Safety sensor when Enabling this feature.
• This setting is to Enable or Disable the Power Close Assist feature.
• When Power Close is "ON", should the door reach the Latch position and cannot fully Close after 3 seconds,
the motor will assist the spring in order to fully Close the door.
This feature is used when the pressures on the door prevent the door from fully Closing
• Use the "UP" and "DOWN" buttons to Enable or Disable this feature.
8.17 Power Close Force (01-05)
• This setting will allow you to increase or decrease the amount of Closing Force needed to fully Close the door
at the Latch position.
• This feature is used to counter act Stack or Wind pressures.
• IMPORTANT: When using the Power Close Force feature, we strongly recommend to wire a Presence Safety
sensor into the input (PC Cancel" on the control board terminal that Cancels out this feature when a pedestrian
presence is detected. PC = Power Close.
• Use the "UP" and "DOWN" buttons to select the desired Closing Force. Use the lowest Force setting needed to
ensure positive Latching in these conditions.
• Check this setting is correctly adjusted.
8.18 Door Seal (Yes/No) Not an Active Function.
To Next Page
Loading...