Micro-Comm S4500 User Manual

- 35 -
Program Installation
A new version of RTU Conguration is required for programming the S4500 and later 32 bit PLCs. For lack of
a better name, this new program is called “RTU Conguration 32”. Throughout this manual the program will be
called “RTU Conguration 32” or “RTU Cong”.
RTU Conguration 32 currently runs on Windows 7 Pro and later, Linux and Mac OS X 10.7 and later.
To Install the Windows version, follow the steps below:
When upgrading to a new version of the program, go to the Control Panels in Windows and double-click on Add/
Remove Programs. Look through the list and remove any old versions of RTU Conguration.
1) Insert the CD into the CD-ROM Drive or download the setup program.
2) RUN the SETUP program located on the CD-ROM.
3) Follow the prompts and do a typical install.
4) After installation, the program icon will appear in the Start menu’s Program list.
When running the conguration program for the rst time you will need to look at the serial port setup screen to
make sure you have the correct COM port number selected. The port setup is located in the program’s “Edit -
Preferences...” menu. Connection to the PLC is by means of a Null-modem cable from the computer’s RS-232
port to the PLC’s COM2 port (display port).
RTU Conguration 32

Micro-Comm S4500 Specifications

General

Brand	Micro-Comm
Model	S4500
Category	Controller
Language	English