- 48 -
RTU Script Language Editor
To enter or edit the Script Language Code, click on the script icon in the tool palette or select “Script Editor” from
the View menu.
Script language can be retrieved from the RTU by clicking the Read button shown at the bottom of the editor
window or by selecting Read RTU Script from the Transfer menu.
Lines starting with a single quote character are comments and do not get sent to the RTU when programming.
Comments are only saved in the .S5C conguration le.
After entering lines of code the user can click the Check button to make sure the syntax looks ok and to see how
many bytes of code have been used. Currently the main script code can’t be larger than 16895 bytes.
The code is then programmed into the RTU’s personality module by clicking the Program button or by selecting
“Program Script” in the Transfer menu.
Script subroutines are edited by selecting the subroutine number from the list in the lower-left corner of the
screen. Each subroutine can be read, programmed and checked separately using this editor. Currently each sub-
routine can be up to 2110 bytes.
To Next Page
Loading...
Need help?
General