September 2012
About This Document
Microair Avionics has developed a series of transponders for use with
OEM applications, and for commercial sale by Microair Avionics. The
manual explains the basic functions and elaborates on the more
sophisticated features, such as altitude display and alerts.
Microair reserves the right to amend this manual as required, to reflect
any enhancements or upgrades to the T2000SFL transponder series.
© Microair Avionics Pty Ltd
Statement:
The T2000SFL owner accepts all responsibility for obtaining the proper licensing before using the transponder. The
coverage you can expect from the T2000SFL is limited to “line of sight”. Low altitude or aircraft antenna shielding by the
aircraft itself may result in a reduced range. Range can be improved by climbing to a higher altitude. It may be possible to
minimize antenna shielding by locating the antenna where dead spots are only noticed during abnormal flight attitudes.
The T2000SFL should be turned off before starting or shutting down aircraft engine(s).
Mobile phones must not be turned on during the operation of the T2000SFL.
T2000SFL-01 (8)
1-6-9 software
REVISION STATUS
Revision Date Change
1.0 11/02/01 Initial Draft
2.2 11/07/01 Voltage Monitoring
2.3 22/08/01 Standby function added
2.4 05/10/01 Hi / Lo alerts added
2.5 12/10/01 Mode and Program Mode menu functions amended
2.6 07/11/01 Deleted SF references
2.7 01/06/02 Assigned Alt & Buffer Alt input amended, Name/Reg relocated to end of Program Mode
2.8 22/11/03 ID and VFR key instructions amended
2.9 08/04/05 Amended for function changes incorporated into software revision 1.6.4
01R3 11/05/06 Amended for 1.6.5 software
01R4 27/05/06 Hardware and software revision references amended Mobile phone to be turned off references
01R5 22/11/06 Display graphics updated
01R6 10/05/07 VFR and ID key descriptions amended
01R7 12/05/08 Warranty Statement Upgrade
01R7-1 19/07/08 Alarm acknowledgement added
01R7-2 25/02/09 Updated Limited Warranty Statement
01R8-0 19/08/09 T2000SFL Rev.8 introduced. Serial Alt data & VSI function added – voltage functions deleted
01R8-1 30/08/10 Firmware 1-6-9 introduced
01R8-2 18-09-12 Default setting for ENC SRC is now SERIAL
To Next Page
Loading...
