Microcare LCD MPPT 20 - To Reset the MPPT to Factory Defaults; The Following Screen will Appear

35
EXTERNAL CONNECTIONS
DO NOT PREES BOTH
DATA and MODE buttons
AT THE SAME TIME
MPPT WILL STOP IN 100
9.5 To reset the MPPT to factory defaults
To reset the MPPT to factory defaults you need to make sure the MPPT Battery and Panel Breaker is
off.
Press and hold the DATA and CHARGE Button and turn on the battery breaker.
The following screen will appear
Once the countdown completes then the MPPT will have been
reset to the default values.
Switch off the battery breaker and restart the MPPT
.