IMPORTANT INFORMATION AND SAFETY INSTRUCTIONS
• Installers should be qualified electricians or technicians.
• The installation information in the manual is for information purposes only.
• The monitoring and operation information in this manual is intended for anyone who needs to
operate the MPPT.
• The MPPT input cannot be paralleled with another PV array.
• Read the instructions carefully before installing and operating the MPPT.
• MPPT connection and installation instructions must be followed.
• The unit should only be opened by skilled personal.
• Keep the MPPT clean and dry.
• The MPPT will not operate without batteries connected to the MPPT.
• The MPPT should be installed indoors, in a ventilated and dry area.
• Mount the MPPT vertically.
• Do not install the MPPT on a rugged or inclined surface.
• Do not install the MPPT near water or in damp environments.
• Do not install the MPPT where it would be exposed to direct sunlight.
• Do not remove the MPPT casing.
• Keep the MPPT away from heat emitting sources.
• Do not block the MPPT ventilation openings.
• Do not leave objects on top of the MPPT
• Do not expose the MPPT to corrosive gasses.
• Install the MPPT away from any explosive gasses.
• Ambient temperature: 0°C – 40°C.
• Use panels of the same type and size in an array.
• Sketches are intended for illustrative purposes only and are not intended to provide an
electrical design.
• Damage caused by reverse polarity is not covered by warranty.
• Do not exceed the MPPT 150 Volt maximum input voltage (Voc) rating.
• Refer to your solar module documentation for the worst-case (coldest) module temperature
voltage, it should provide the Voc vs. temperature data.
• Contact the battery manufacturer or supplier for the correct charging specifications.
• Incorrect charging can damage or destroy batteries.
PLEASE BE AWARE:
WARRANTY WILL BE NULL AND VOID IF PANEL
SURGE PROTECTION IS NOT INSTALLED WITH
ALL LCD MPPT INSTALLATIONS
To Next Page
Loading...