CCOONNNNEECCTTIINNGG TTHHEE SSYYSSTTEEMM
The development system box contains the development system, product CD, USB
cable, RS232 cable and this manual.
The first thing to do is to take the system out of the box. Unpack the USB cable and
connect it to the PC. Please use USB ports on the back of the PC with direct con-
nection to the motherboard.
Install the PICFLASH2 programmer and drivers. Start the installation from the
product CD: CD_Drive:/product/zip/PICFlash2_setup.exe.
After the installation connect the USB cable to the EasyPIC4 board.
Run and use PICFLASH2 as explained in the document ‘PICflash2 programmer’.
After these 4 steps, your EasyPIC4 is installed and ready for use. You should try to
read a program from the chip or to load an example from the examples folder of
mikroElektronika’s compilers for PIC or from the product CD:
CD_Drive:/product/zip/easypic4_examples.zip.
CONNECTING THE SYSTEM
Step no.1
Step no.2
Step no.3
Step no.4
To Next Page
Loading...