© Microhard 84
4.0 Configuration
Image 4-5-2: Serial > Settings Configuration
4.6.3 Serial > GS0
This tab only appears if the pMDDL has been set to operate as a USB Device (Pin 14 connected to GND
through a 1k resisitor). Microhard USB Serial Composite Drivers are available which allow the pMDDL to
appear as a serial device to a USB Host (PC etc.)
The USB port can be set to “Idle” or to operate as a Data port as seen below:
GS0 Serial Port Configuration
The USB port configuration is identical to the Serial Port > Settings parameters. For help or definitions of
each field, refer to the previous section of this manual which describes the available settings.
To Next Page
Loading...
