DOC 6501_Release V
ATS-6501 Users Guide
191
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4374A
[OK] 2016-10-03T18:45:33Z
timescale_filtermax:
Description: Change the timescale filter averaging time (units of time-constants). This
parameter determines how many timescale_steer_timeconstants it will take to steer out an
offset. For example if the timescale_steer_interval is 1 hour, the timescale_steer_
timeconstant = 3hr, and timescale_filtermax = 0, the system will steer the offset out in
3hrs. If the timescale_filtermax = 2, the system will steer the offset out in approx 6 hrs.
Usage: timescale_filtermax < integer >
Query:
ATS-6501>settings reference:timescale:kas2:tsfiltermax
2
[OK] 2013-09-04T16:18:27Z
timescale_filterref:
Description: Change which clock serves as the filter reference for 4393 clock
measurements. This command specifies which clock going into the 4393 module will serve
as the measurement reference for the other clocks being measured with the 4393. The filter
reference must be defined in timescale mode for the unit to operate correctly.
Usage: timescale_filterref < clockName >
timescale_filterref Test
Query:
ATS-6501>settings reference:timescale:kas2:tsfilterref
Test
[OK] 2013-09-04T16:18:27Z
timescale_steer_epoch:
Description: Change the timescale steer epoch. The timescale steer epoch is an offset
from when the nominal time the steer occurs. For example if the timescale_steer_interval is
1 hour and the timescale_steer_epoch is set to 3sec, the steer will occur at 3sec past the top
of the hour.
Usage: timescale_steer_epoch < seconds> Default = 0
Query:
ATS-6501>settings reference:timescale:kas2:tsepoch
To Next Page
