DOC 6501_Release V
ATS-6501 Users Guide
192
0
[OK] 2013-09-04T16:26:42Z
timescale_steer_interval:
Description: Change the timescale steer interval. Time interval in seconds between
timescale steers.
Usage: timescale_steer_interval < seconds> (Default = 3600)
Query:
ATS-6501>settings reference:timescale:kas2:tsinterval
3600
[OK] 2013-09-04T16:26:42Z
timescale_steer_timeconstant:
Description: Change the timescale time constant. This parameter specifies how strong the
steering will be. Supposing the timescale is offset from UTC by 100ns, then for the case of
timescale_filtermax = 0, the system will steer out the entire 100ns in one
timescale_steer_timeconstant. If timescale_filtermax = 3, the system would steer out the
entire 100ns in 3 timescale_steer_timeconstants.
Usage: timescale_steer_timeconstant < seconds> Default = 10800.
Query:
6501A_60>settings reference:timescale:kas2:tstimeconstant
10800
[OK] 2013-09-04T16:26:42Z
unlog:
Description: Remove a GPS log. The unlog command removes a specific log from the
requested list of GPS logs. It can also be used to remove all the requested logs by issuing
the "all" parameter instead of a specific log name.
FTP and realtime logs currently requested by the user can be viewed by typing settings
gps_logging:ftp:log_selection and settings gps_logging:rt:log_selection respectively.
See also: log, log_enable, save_logs, list_logs, delete_logs
Usage: unlog <rt | ftp> <LOGA | all>
LOGA Name of requested GPS log
Command Example:
ATS-6501>unlog ftp waas9a waas9a = [type]
Query:
ATS-6501>settings gps_logging:ftp:log_selection
[bestposa] ontime 7200
[rangea] ontime 60
[rawalma] onchanged
[rxhwlevelsa] ontime 60
To Next Page
