17
Operation
Open Door
1. Swing door handle to
left, UNLATCHED
postion.
2. Push door & cross
arm assembly toward
right while pulling out-
ward on assembly.
Fill Chamber with Water.
1. Press and hold down Fill / Vent
lever until incoming water from res-
ervoir is approximately 1/2" (1.27
cm) from front of chamber rim.
Place Trays Into Chamber.
1. Load trays into chamber. Do not pack
contents of trays too tightly as air must
circulate around each object for proper sterilization and drying.
NOTE
It takes approximately 30 to 40 sec-
onds before water becomes visible
in chamber.
NOTE
Always include an internal process
indicator strip with each sterilizer
load to verify gross heat penetra-
tion.
Operation
Return To Table Of Contents
To Next Page
Loading...