6
plug on sterilizer power cord must be plugged into a matching three-pronged,
grounded, isolated, correctly polarized receptacle. Check serial number label
on back panel of sterilizer to verify voltage rating for unit.
DESCRIPTION
Operational Features
M7 SpeedClave™ Sterilizers . . .
• have a three prong plug-in operation for standard electrical outlets.
• have a self-contained reservoir to hold distilled or demineralized water. No
exterior plumbing required.
• have a lever for Fill / Vent located on front of unit for easy access.
• will emit an audible signal when time on cycle timer has elapsed.
• after manually venting steam pressure from chamber, door handle is placed
in middle “vent” position to facilitate drying.
• have a Cycle Timer to control amount of time that load is exposed to steam
at set temperature.
• have a Temperature Regulator that turns heating element On and Off to
control operating temperature in chamber.
• have a Pilot Light that illuminates whenever heater is energized.
• have a Low Water Cut-Out Switch to prevent operation when water level is
low.
• have a Reset Button to restore operation after Low Water Cut-Out Switch
has tripped and water has been added.
• have a drain coupler located on front for easy draining of self contained res-
ervoir.
Mechanical Features
The M7 SpeedClave™ sterilizers . . .
• have a tray rack which can hold one small and two large trays. The tray rack
can be removed for periodic cleaning of the chamber, tray plate, and tray
rack.
• have a Temperature Gauge to indicate internal chamber temperature. Dial
is graduated from 170 to 270°F (77 to 132°C).
• have a drain coupling, adapter and hose assembly allows draining reservoir
from front of unit.
Description
Installation
Return To Table Of Contents
To Next Page
Loading...