In order to achieve good cleaning
results, the machine needs to operate
with soft water. Hard water results in the
build-up of calcium deposits on the
load and inside the wash cabinet.
Mains water with a hardness level
higher than 0.7 mmol/l (4° dH – German
scale) needs to be softened. This takes
place automatically in the integrated
water softener.
–
The water softener requires
reactivation salt.
–
The machine must be programmed
to correspond to the water hardness
in your area.
– Your local water authority will be able
to advise you on the water hardness
in your area.
Where the water hardness fluctuates
e.g. between 1.4 - 3.1 mmol/l (8 -
17 °dH German scale), always
programme the washer-disinfector to
the higher value (17 °dH or 3.1 mmol/l
in this example).
The built-in water softener has
settings from 1 °dH - 60 °dH (0.2 -
10.8 mmol/l).
For future servicing it is useful to make
a note of your water hardness level.
Enter the water hardness below:
°dH
Programming the water
softener
^
Switch off the machine.
^
Turn the programme selector to f.
^
Press 4 and 6 at the same time,
hold them in and, whilst doing so,
switch the machine on with the I-0
switch.
The current programme status P.... will
appear in the display.
The indicator light p / 6 will come on.
^
Press 3 once.
E01 will appear in the display.
^ Turn the programme selector one
switch position clockwise (1 o'clock
position).
The number 19 will appear in the
display (the factory water hardness
default setting in °dH, equivalent to 3.4
mmol/l).
^ Press 4 repeatedly as necessary, or
hold it in until the required value
(degree of hardness in °dH) appears
in the display.
See table on the next page for water
hardness settings in °dH, mmol/l and °f.
Once the number 60 has been
reached, the counter will begin again at
0.
^
Press 6.
SP will appear in the display.
^
Press 6 again.
The setting will now be stored in
memory. The display will clear.
The machine is now ready for use.
Water softener
15
To Next Page
