Cleaning the drain pump and
non-return valve
If water has not been pumped away at
the end of a programme, the drain
pump or the non-return valve might be
blocked. They are easy to clean.
^
Take the filter combination out of the
wash cabinet.
^ Release the locking clamp.
^
Lift up the non-return valve and rinse
under running water.
The drain pump is situated under the
non-return valve (see arrow).
^ Before replacing the non-return
valve, check that the drain pump is
free of obstructions.
^ Carefully replace the non-return valve
and secure with the locking clamp.
For safety reasons, the load should
be cleaned and disinfected again.
Other problems
61
To Next Page
