Buzzer
The buzzer can be programmed as follows:
– a constant tone at the end of a programme, and/or
– at one second intervals as a fault warning.
The buzzer settings are displayed as numbers:
100 Switched off
101 Programme finished (factory default setting)
102 Fault indication
103 Programme finished + fault indication
Step Display / Result
^
Press 3 until E01 appears.
E01
^ Turn the programme selector to 6 (the 10
o'clock position).
100 to 103
^ Press 4 repeatedly or hold pressed in until the
required number appears in the display, e.g.
103.
103
Value set:
The buzzer will sound at the setting selected for 30 seconds.
To switch the buzzer off early:
–
turn the programme selector to f,
–
press 4.
–
interrupt the electricity supply, e.g. open the door.
Programmable functions
42
To Next Page
