Changing programme parameters
The parameters for programmes A, B and C can be changed to suit particular
requirements. To do this the temperature and the temperature holding time in the
Main wash and Final rinse programme blocks can be changed.
The programme chart at the end of these instructions shows the factory default
settings for the temperature and temperature holding time of the individual
programme blocks.
Please make a note of any changes in the appropriate section of the programme
chart.
Changing the temperature
–
Values which can be set for the temperature: 30 °C - 70 °C.
Step Display / Result
^ Press button 3 repeatedly or hold pressed in until
the level of the programme block you wish to change
appears in the display.
E03 for Main wash
E05 for Final rinse
^ Turn the programme selector to the programme you
wish to change, e.g. C.
°C ~65
^ Press 4 repeatedly or hold pressed in until the
required value appears in the display, e.g. 70 °C.
°C ~70
Changing the temperature holding time
–
Values which can be set for the temperature holding time: 1-10 minutes
Step Display / Result
^
Press button 3 repeatedly, or hold pressed in until
the level of the programme block you wish to change
appears in the display.
E03 for Main wash
E05 for Final rinse
^
Turn the programme selector to the programme
you wish to change, e.g. A.
min _ 1
^
Press 4 repeatedly or hold pressed in until the
required value appears in the display, e.g. 10.
min _ 10
Programmable functions
43
To Next Page
Loading...
