For future sevicing work, please document any alterations to the factory default
settings.
Enter any alterations in the appropriate box.
General notes:
–
Switch positions that have not been allocated a function are indicated in the
middle part of the display by a bar ( - ).
–
The programming level is called up via the stop position f.
It is shown as E.. in the display.
–
For validated processes, any changes made to programmes or dispensing
systems must be documented in a log book kept with the machine. The
machine's processes must be re-validated.
The following applies to all programmable functions:
To activate programming mode
^ Turn the programme selector to f.
^ Switch off the machine.
^ Press 4 and 6 at the same time,
hold them in and, whilst doing so,
press the I-0 switch.
The current programme version P.. will
appear in the display. The p / 6
indicator light comes on.
To save values and exit from programming mode
^
Press 6.
SP will appear in the display.
^
Press 6 again.
The change is now saved.
To exit from programming mode without saving
^
Switch the machine off with the I-0
switch.
The change will not be saved.
Programmable functions
39
To Next Page
Loading...
