Level and secure the machine
To ensure stability, the machine must
first be aligned and then screwed to the
worktop.
^
Open the door.
^ Secure the machine to the front edge
of the worktop using screws through
the holes on the left and right hand
sides of the front trim.
Do not use silicone sealant to seal
the gaps between the machine and
any neighbouring units as this would
hinder ventilation to the circulation
pump.
Cover plate (protects the worktop)
If required, a special cover plate can
be ordered from Miele.
This cover plate protects the underside
of the worktop against steam rising
from the machine.
Installing the machine
65
To Next Page
Loading...
