Troubleshooting
64
Unsatisfactory results
Problem Cause and remedy
The food in the pan
does not heat up when
the Auto heat-up func-
tion is switched on.
A large amount of food is being heated up.
Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
Use a different pot or pan which conducts heat
properly.
General problems or technical faults
Problem Cause and remedy
The hob or cooking
zones will not switch
on.
There is no power to the hob.
Check whether the circuit breaker has tripped.
Contact a qualified electrician or the Miele
Customer Service Department (for the minimum
fuse rating, see data plate).
There may be a technical fault.
Disconnect the hob from the electricity supply for
approx. 1minute. To do this:
– tripping the relevant mains fuse or screwing the
fine-wire fuse out completely, or
– switching off at the residual current device.
If the hob will still not turn on after resetting the trip
switch in the fuse box or the residual current
device, contact a qualified electrician or the Miele
Customer Service Department.
A smell and vapours are
given off when the new
appliance is being used.
The metal components have a protective coating.
When the appliance is used for the first time, this
causes a smell and possibly also vapour. The
material from which the induction coils are made also
gives off a smell in the first few hours of operation.
With each subsequent use, the odour is reduced until
it disappears completely. The smell and any vapours
given off do not indicate a faulty connection or
appliance and they are not hazardous to health.
To Next Page
Loading...
