Problem solving guide
107
Cleaning the water inlet filter
A filter is incorporated in the screw connection to protect the water
intake valve. The filter must be cleaned when dirty, otherwise
insufficient water flows into the wash cabinet.
The plastic housing of the water connection contains an
electrical valve.
The housing must not be dipped in water.
Recommendation
If the water supply contains a large number of insoluble substances,
we recommend fitting a large-area filter in the connection between
the stopcock and the safety valve threaded union.
This water filter is available from a Miele dealer or from the Miele
Customer Service Department.
To clean the filter:
Disconnect the dishwasher from the mains.
To do this, turn off the dishwasher, switch off at the socket and
unplug it.
Close the stopcock.
Unscrew the water intake valve.
Remove the seal from the screw thread.
Withdraw the filter using combination or pointed pliers and rinse
clean under running water.
Refit the filter and seal. Make sure they are fitted correctly.
Screw the water intake valve to the stopcock. Make sure not to
cross-thread the connection.
Open the stopcock.
If water leaks out, the screw connection may not be connected
securely or it may have been screwed on at an angle.
Fit the water intake valve straight and screw it in place.
To Next Page
Loading...
