Miele PG 8060 - Setting the Water Hardness Level

Filling the salt reservoir
28
Setting the water hardness level
The water softener can be set between 0 - 12.6mmol/l (0 - 70°dH).
 Select the Further settings menu.
 Select Water hardness and confirm your choice with theOK button.
Water hardness
19
(0 - 70 °dH)
°dH
The factory default for the water softener is set to a hardness of
3.4°mmol/l (19°dH).
When adjusting the setting, please consult the following table.
Where the water hardness fluctuates, e.g. between 1.4 - 3.1 mmol/l (8
- 17 °dH), always programme the dishwasher to the higher value, 3.1
mmol/l (17 °dH) in this example.
 Use the  (higher) and  (lower) arrow buttons to set the water
hardness required and confirm your entry using the OK button.