Problem solving guide
102
Door
Problem Cause and remedy
The door opens again after
being closed
If the door is closed with too much force, the comfort door
locking mechanism will open it again.
Guide the door into the door lock with less force.
Door blocked Protruding wash load item obstructing the door.
Sort the wash load so that that it does not obstruct the
door.
Close the door.
The Comfort door lock is blocked.
Try to open the door carefully (without using force) by
pulling on the door handle.
If the door is still blocked:
Open the door using the emergency release.
Close the door and try to open it again using the
button.
If it is still blocked:
Contact the Miele Service Department.
Warning. Cabinet hot! Open
anyway?
When pressing the button, be aware that the
temperature in the wash cabinet is over 70°C.
When the door is opened, hot steam and chemical
agents can escape!
Open the door only when strictly necessary.
The door is open a fraction
and cannot be closed us-
ing the button.
This is not a fault.
The Comfort door lock has opened the door slightly at the
end of the programme.
Open the door. The door can now be closed completely
again using the button.
Obstruction sensor This is not a fault.
The door is locked while the door locking mechanism
retracts to the lock position.
Open the door and wait until the door locking
mechanism reaches its final position.
To Next Page
Loading...
